"Raised" shifter boot area - far from perfection, but functional
"Raised" shifter boot area - far from perfection, but functional
Date: 12/31/1969
Views: 5374
|
Shifter was notched in one place with a grinder until I cut enough and got it hot enough to finish bending, then re-welded. This
Shifter was notched in one place with a grinder until I cut enough and got it hot enough to finish bending, then re-welded. This is in 1st gear
Date: 12/31/1969
Views: 1899
|
Reverse
Reverse
Date: 12/31/1969
Views: 7560
|
2nd gear
2nd gear
Date: 12/31/1969
Views: 937
|
5th gear
5th gear
Date: 12/31/1969
Views: 877
|
Clearance hole for the slave cylinder is still unfinished
Clearance hole for the slave cylinder is still unfinished
Date: 12/31/1969
Views: 1530
|
Looking forward after lowering the transmission mount
Looking forward after lowering the transmission mount
Date: 12/31/1969
Views: 1253
|
PTO clearance
PTO clearance
Date: 12/31/1969
Views: 1504
|
More PTO clearance
More PTO clearance
Date: 12/31/1969
Views: 1631
|
Driveshaft to floor clearance
Driveshaft to floor clearance
Date: 12/31/1969
Views: 873
|
Driveshaft to floor clearance - note the rub mark on the driveshaft from just 10 miles.
Driveshaft to floor clearance - note the rub mark on the driveshaft from just 10 miles.
Date: 12/31/1969
Views: 943
|
DCarrier bearing view
DCarrier bearing view
Date: 12/31/1969
Views: 855
|
DCP_0007.JPG
DCP_0007.JPG
Date: 12/31/1969
Views: 1185
|
Rear dump headers, driver's side
Rear dump headers, driver's side
Date: 12/31/1969
Views: 930
|
IFS front suspension, looking forward from under the truck
IFS front suspension, looking forward from under the truck
Date: 12/31/1969
Views: 1982
|
Looking to the rear, starting at approximately the carrier bearing crossmember. Passenger muffler cut off and mid-replacement
Looking to the rear, starting at approximately the carrier bearing crossmember. Passenger muffler cut off and mid-replacement
Date: 12/31/1969
Views: 1146
|
Starter, with starter wire re-routed UNDER the frame and outboard
Starter, with starter wire re-routed UNDER the frame and outboard
Date: 12/31/1969
Views: 1722
|
Another look at the header
Another look at the header
Date: 12/31/1969
Views: 1898
|
2012-09-26_19-55-15_181.jpg
Date: 09/26/2012
Views: 1910
|
|